"maxzsim via SQLMonster.com" <u14644@uwe> wrote in message
news:606cbc5c88012@uwe...
> Hi ,
>
> I have setup Replication alert to send email to me while the agent failed
> or
> retry from the Replication Monitor i can see my replication is either
> retrying or fail but it did not seem to trigger the Replication Alert as
> the
> count is still showing 0
>
> is there any way to check why it was not triggered ?
>
> appreciate ur advise
>
> tks & rdgs
>
> --
> Message posted via http://www.sqlmonster.com

Hilary Cotter wrote:
>The alert should be raised. It is possible that a certain class of failures
>will not raise the alert. In this case you might want to add a job step that
>is run on the previous set failure so that it raises an alert.
>
>> Hi ,
>>
>[quoted text clipped - 10 lines]
>>
>> tks & rdgs

"maxzsim via SQLMonster.com" <u14644@uwe> wrote in message
news:60a974f7889af@uwe...
> Hi ,
>
> Do you mean to put in the job in the "Response" tab ?
>
> I have actually "asked" the system to execute a job as well as to netsend
> me
> in event of the "Replication Agent failure"
>
> tks & rdgs
>
> Hilary Cotter wrote:
>>The alert should be raised. It is possible that a certain class of
>>failures
>>will not raise the alert. In this case you might want to add a job step
>>that
>>is run on the previous set failure so that it raises an alert.
>>
>>> Hi ,
>>>
>>[quoted text clipped - 10 lines]
>>>
>>> tks & rdgs
>
> --
> Message posted via http://www.sqlmonster.com

Hilary Cotter wrote:
>That's right!
>
>> Hi ,
>>
>[quoted text clipped - 17 lines]
>>>>
>>>> tks & rdgs